Instructions for use
Mounting M-ID03 - Ethernet
In order to be able to use the module, first we must connect the power supply and ethernet communication, as shown in the illustration below:
Settings
- Before accessing the panel, to send the commands to the module, we must first ensure that it is in the same network range as your computer, for this we will configure IPV4 on your machine.
- After clicking on the protocol configuration, it will be available for you to configure your machine's network.
- You must configure it according to the network range of your interface.
Warning
Remembering that every configured IP always needs to be static, to work correctly.
Web services
| Command | Function |
|---|---|
| URL/00 | relé-01 Off |
| URL/01 | relé-01 On |
| URL/02 | relé-02 Off |
| URL/03 | relé-02 On |
| URL/04 | relé-03 Off |
| URL/05 | relé-03 On |
| URL/06 | relé-04 Off |
| URL/07 | relé-04 On |
| URL/08 | relé-05 Off |
| URL/09 | relé-05 On |
Commanding Interface
- After configuring, we can access the interface through its configuration panel, with the address 192.168.1.4, by default it will open with port 8080.
IO: default name of the relay to be activated.On: relay – activated.Off: relay – off.Save: saves relay activation.Undo All: Undo changes that were not saved.Refresh: reloads the page.Configuration: access the firmware configuration page.
IP/Port Configuration
Name: interface name.IP Address: interface access IP address.Gateway: interface gateway.Netmask: mask of the interface network.Port: interface connection port.MAC Address: access control address of the interface.Features: optional tools.IO: identification of the relay on the board.Type: type of relay activation.Name: relay name.Invert Boot state: Inverts boot status when the interface is turned on.Timer: relay activation time.Save: save settings.Undo All: Undo settings made before saving.Reboot: restart interface.Refresh: reloads page.IO Control: relay control page.
Saving settings
When you save the settings, the interface will ask you to wait 5s to save the settings.
